← User Guide

Playback & Editing

Playing Back Ideas

Tap any recording in your library to open it. Press play to listen back.

A-B Looping

Under the play controls is a switch with two modes, Loop and Trim. It decides which buttons appear below it and what your taps and drags on the waveform edit. Loop is the default. A loop repeats one section while you listen, which is useful for isolating a phrase you want to focus on, and it never changes the recording.

To loop a section of your recording:

  1. With Loop selected, play or scrub to where the section starts and tap A
  2. Play or scrub to where it ends and tap B
  3. The section between A and B loops continuously, and Looping appears next to the buttons

You can also set a loop on the waveform itself: tap once for A and again for B, or drag across the section you want. Drag the A or B handle to adjust an edge, and tap the × button to clear the loop.

For finer placement, pinch the waveform to zoom in, up to 10×. While zoomed in, dragging scrolls the waveform, but you can still drag the handles. On iPhone, rotate to landscape for a bigger waveform.

Variable Speed Playback

Slow down or speed up playback to catch details or hear how something sounds at a different tempo.

Trim

Trimming cuts a recording down to just the part you want to keep. It has its own mode, so setting A and B never trims anything.

Switch to Trim (this clears any A-B loop), then mark the part to keep in whichever way suits you:

The parts that will be cut are dimmed, and Trimmed shows how long the result will be. Press play to hear it: only the part you’re keeping plays, on a loop. To adjust, drag either edge, or tap the waveform to move the nearer edge to that spot. The × button clears your trim points so you can start over.

When it sounds right, tap Apply Trim and choose:

Trimming works on both WAV and M4A recordings. Either way, the trimmed audio is saved as M4A.

Re-Transcription

Once you’ve analyzed a recording (see Getting Started), you can re-run the transcription in a different language. Useful if the first pass picked the wrong language, or if you want to see how your vocals map to another language’s speech-to-text.